Troubleshooting

Table of Contents

There is no power

  • Ensure the AC power cord is connected securely.
  • Ensure the plug is fully inserted into the wall socket and is switched on.
  • Check fuse in the mains plug or adaptor.

 

There is no sound

  • Make sure the unit is not in Standby mode.
  • Check that source component is properly connected.
  • Check that your speakers are properly connected.
  • Ensure that the correct input has been selected via the Balanced/Unbalanced switch.
  • If possible, use different interconnect cables and speaker cables.
  • Check your source devices’ volume control to ensure this is not muted.
  • Check with alternative source device.

 

There is no sound on one channel

  • Check speaker connections.
  • Check interconnects.

 

There is weak bass or diffused stereo imaging

  • Ensure that speakers are not wired out of phase.

 

There is a loud buzz or hum

  • Ensure no interconnects are loose or defective.

 

The LED standby button is red

  • Check the ‘Protection Circuitry’ section for troubleshooting steps.