1. AC power socket
2. USB sockets
Pre-fitted Wi-Fi dongle and connection for USB HD/flash disk or optional BT100 Bluetooth audio receiver.
The USB ports are not intended for connection to Apple mobile devices, no functionality, charging or otherwise, is supported.
The Wi-fi dongle is pre-fitted. Please leave connected. Your unit will automatically default to an Ethernet connection if one is made. If you are using this CXN v2 with Wi-Fi please make sure your unit is positioned within range of your wireless router.
Important note:
Do not connect/disconnect the Wi-Fi dongle when the unit is on.
3. Ethernet
4. Digital inputs
5. IR (Infra-Red) emitter in
6. Digital outputs
7. Control bus
For connection to other CX series products. Features vary according to other product functionality.
8. USB audio in
For connecting to PC/MAC computers.
Ground lift switch
Enable 'Lift' to eradicate hum noise through the speakers.
9. Balanced audio output
For use with XLR connections.
Note: XLR connectors should be wired as follows: Pin 1: Ground, Pin 2: Hot (in-phase) and Pin 3: Cold (phase-inverted).
10. Line output