Skip to main content

On later units, a switchable TV mode was introduced that improves the performance of the DacMagic 200M whilst using a TV as a source. This configures the DacMagic 200M with a higher bandwidth to reduce glitches and interruptions when connected to a TV.

TV Mode

TV mode is only effective on the D2 input and can be enabled and disabled by following the instructions below.

  1. With the DacMagic 200M in standby mode, long press the source button.
  2. Two LEDs will light up to indicate the TV mode status.

TV mode on enabled: 44.1/192 LEDs light up

TV mode enabled

 

TV mode disabled: 96/705.6 LEDs light up

TV mode disabled